Roughly 60% of water is used outdoors making harvesting rainwater a smart, green and easy way to conserve water helping both the environment and your water bill too. The Clean Rain™ Ultra Downspout Diverter from Atlantic Water Gardens is an all-in-one rainwater filtration and collection system designed to ensure the water you store is bug and debris-free. The Ultra Downspout Diverter installs directly into the downspout of your home's gutter and uses the force of rainwater to deflect leaves, debris and bugs off of its leaf slide and stainless steel (mosquito-proof) mesh screen.
Depending upon the intensity of the rainfall the Smart Sense™ First Flush valve will divert dirty roof water from the initial rainfall and then collect the clean water that comes after. The Downspout Diverter is compatible with standard garden hoses, 1" sump hoses, 1.5" pool hoses and 3" schedule 40 pipes. Any of these hoses can be connected directly to the Clean Rain Diverter and used to fill up a rain barrel or cistern, pond, pool or even to directly provide water to plants and trees.
The Clean Rain Ultra Downspout Diverter can be installed at any height along the gutter downspout. It is recommended to install it at a reachable height to make maintenance, such as removing leaves and debris, an easy task. To install, 29.3" of downspout will need to be removed as this is where the Downspout Diverter will be setup. It comes with 2 downspout adaptors to fit 2" x 3", 3" x 4", 3", 4" and schedule 40 pipes. The Downspout Diverter will work automatically upon installation and can be switched off when desired if you don't need to divert water. Its exterior is white but can be painted to match the color of the downspout it is being connected too for a clean look.
1. Remove 29.3" of downspout from where the Clean Rain™ is to situated. Ensure all edges are clean and smooth.
2. Remove the cap and use snips to remove a section to fit the downspout.
3. Remove the cover by flexing outwards at the top.
4. Fit the correct downspout adaptor to the bottom of the Clean Rain.
5. Slide the cap up the top section of the downspout and hold temporarily in place.
6. Install the Clean Rain by positioning it securely on the bottom section of the downspout.
7. Screw the top of the Clean Rain in position through the screw slots provided. Ensure appropriate screws and anchors (if required) are used.
8. Check the placement of the Vibrating Screen. It must sit behind and below the front face.
9. Insert the Leaf Slide into slot holes.
10. Re-install the front cover.
11. Slide the cap back down the downspout until it sits securely on the top of the Clean Rain unit.
Rain Head - The leaf slide and vibrating screen can both be removed when the cap and cover are off by lifting up and out. If cleaning is required simply hose or brush off any debris.
Outlet - The outlet has an internal mosquito barrier that prevents any mosquitoes from entering the tank. To clean simply remove the outlet by holding the unit in one hand and with a firm pull remove the outlet adaptor. The mosquito barrier sits within the outlet and can be removed by hand.
First Flush - The Smart Sense™ valve may require the occasional clean to remove any build-up of sediment. To clean, remove the Clean Rain from the wall and take the bottom adaptor off the unit. To maintain optimum performance the washers based at the bottom of the Smart Sense valve should be replaced approximately every 12 to 24 months.